Ambient Conditions - Quadral AURUM A10S Bedienungsanleitung

Troubleshooting
The A10S is no longer detected in the network:
- check to see that your WLAN is working correctly
- ensure that your A10S is close enough to your WLAN router
- restart the A10S
- use the network cable to connect the A10S to the network
- reset back to the default factory settings
App problems
- ensure that your smartphone operating system is up-to-date
- Restart the A10S and smartphone / tablet
Specifications
Wi-Fi 802.11b/g/n
Ethernet 10/100 Mbit/s
Supports the following data formats:
- MP3
- AAC
- WAV
- FLAC
- WMA
- LPCM
- ALAC
10

AMBIENT CONDITIONS

The remote control has a range of up to 6 m and works without any problems from a radiating angle of up
to 30° in relation to the front of the equipment. Dust on the transmitter or dirt on the receiving sensor and
operating it in the vicinity of fluorescent lights might reduce the range. A direct line-of-sight connection
between the transmitter and the receiver is needed.
Notes about the removal and the correct environmentally-friendly disposal of old batteries.
The symbol shown here can be found on the equipment's enclosure, the packaging as well as in the doc-
uments or the operating manual. It tells you that batteries provided with the equipment as well as those
supplied with or fitted in other units must never be disposed of in household waste. They must be disposed
of in an environmentally-friendly way (in compliance with the local regulations or European Directives
2002/96/EU and 2006/66/EU).
You should find out where the nearest collection point for electronic scrap is or where the recycling site is.
Correct disposal of the equipment and the batteries will help to preserve our resources and prevent physi-
cal and environmental damage. The battery (CR2032) supplied with the remote control contains lithium and
it must be disposed of in an environmentally-friendly way as described above.
Proceed as described in the following section to replace or remove the battery fitted in the remote control.
1. Undo the screw in the cover underneath the remote control and then remove the cover.
2. Remove the battery by sliding it out of its holder.
3. You must ensure that the new battery's polarity is correct when you fit the new one! The side of the
battery marked with (+) must point upwards so that it makes contact with the part of the holder marked
with (+).
4. Refit the cover and use the screw to secure it in place.
EN
11