Nowsonic Stagetrip 10 Bedienungsanleitung Seite 7

www.nowsonic.com
Connectors and controls
You can access the following connectors and controls on the right-
hand side panel of the Stagetrip 10/12:
2 3
4
5
6
7
1
Nowsonic Stagetrip 10 / Stagetrip 12
1. POWER switch and fuse
Use this switch to turn the internal power amplifier of the Stagetrip
10/12 on or off: when power is properly supplied through the
IN
socket (3) to the speaker, the
The fuse of the internal amplifier is located adjacent to the
switch: if the PO WER indicator does not light after turning on the
switch and the coaxial speaker does not produce any audible noise, be
sure to check the internal fuse first.
NOTE: DISCONNEC T THE PO WER CON CABLE BEFORE OPE-
NING THE FUSE HOLDER.
ver for opening the fuse holder, then remove the holder from the
enclosure. replace with a fuse of the same type (
ALWAYS
); failing to do so might result in damage to the power am-
250 V
plifier.
8
2. socket
POWER OUT
9
The PowerCon-type POWER OUT
for passing the input power through to following devices.
NOTE:
Note that the
current of 4 A. Therefore, if the following consumer requires more
power, connect it directly to the mains.
7
User manual
POWER 4
indicator ( ) will light.
Use a suitable tool such as a screwdri-
socket of the Stagetrip 10/12 allows
POWER OUT
port supplies a maximum
GB
POWER
PO WER
T2.0AL