Volkswagen Composition Media Montageanleitung Seite 6

Assembly Instructions
Genuine activation "Composition Media" voice operation
Scope of delivery:
1 x Software certificate
◆
Required special tools, test and measuring equipment and auxiliary equipment:
Vehicle diagnostic tester with ODIS-Service from Version 19.21
◆
Battery charger -VAS 590X-
◆
Sequence of operations:
Note
This software update has to be carried out by an authorised workshop. In some cases supplementary, vehicle-
◆
specific literature is required. Incorrect handling may lead to damage to the vehicle.
It must be ensured that the open-circuit voltage of the vehicle battery is at least 12.5 Volts. To maintain the on-
◆
board voltage during the complete procedure, connect a -VAS 590X- battery charger.
Neither diagnostic nor any other operations may be performed with the vehicle diagnostic tester during the
◆
software update.
The activation code, the activation number and the activation pin are required for software actualization . For this
◆
data, refer to the software certificate enclosed.
Subject to technical modifications.
◆
 If the ignition is replaced, connect the vehicle diagnostic tester to the diagnostic connection on the vehicle.
 Switch on the ignition.
 Select the "Guided troubleshooting" mode on the vehicle diagnostic tester and then identify the vehicle.
 After the control units requests to change to "Special functions" and start the test program "Activate functions
system".
 Select pushbutton "Activate function".
 Enter the diagnostics address "5F" (for the control unit to be activated) on the screen and follow the vehicle
diagnostic tester instructions.
After activation, the online connection is established and the software update carried out.
 After successful activation, restart the infotainment system (press the On/Off switch of the Infotainment system for
more than 10 seconds).
 End Guided troubleshooting.
 Disconnect the connection to the vehicle diagnostic tester.
8
5G0 054 802
1 x Assembly Instructions
◆