Remote Control; Specifications - Soba XT910 Bedienungsanleitung

TOWER FAN/AIR PURIFIER XT910
V. STARTING UP
1. Place the Tower Fan on a dry, flat surface.
2. Check that the rated voltage corresponds to the socket voltage.
3. Plug the mains plug into the socket and press the ON/OFF button. The ventilator
will start running. The speed of the fan can be regulated by pressing the blower
strength button.
low
mid
high
4. When the oscillation button is pressed the tower fan starts to oscillate back and
forwards. This function can be switched off by pressing the button again.
5. When the timer button is pressed the fan runs for the time chosen before
switching off automatically.
Press once
Press twice
Press three times
6. The air purifying function is activated by pressing the air purifying button.
Proceed as follows:
• Draw the water tank out and fill the water tank with water (min. 1.3 litres /
max. 1.6 litres)
• Recommendation: Add a few drops of essential oil to the water.
7. Press the ON/OFF button to switch the fan off.
The same functions can be activated/deactivated using the remote control.
VII. REMOTE CONTROL
Proceed as follows to take out the remote control:
1. Push the remote control towards the main body (Fig. 1).
2. Half of the remote control will be ejected (Fig. 2).
3. Pull out the remote control as shown (Fig. 3).
Fig. 1
N.B. Remove plastic sticker in the battery compartment before using the
remote control for the first time.
VIII. SPECIFICATIONS
Voltage
Power
Subject to change without prior notice.
red indicator
orange indicator
green indicator
Running time 2 hours
Running time 4 hours
Running time 8 hours
Fig. 2
220-240 V~ 50/60Hz
50 W
red indicator
orange indicator
green indicator
Fig. 3
3
INSTRUCTION MANUAL
Replacing the battery