Explication Of Warning Symbols; Safety Instructions - IKA T 653 Betriebsanleitung

Source language: German

Explication of warning symbols

Safety instructions

Unpacking
Correct use
Set-up and Commissioning
Maintenance and cleaning
Accessories
Technical data
Warranty
• R ead the operating instructions in full before
starting up and follow the safety instructions.
• K eep the operating instructions in a place where they
can be accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• The stand pillar must be inserted into the baseplate so that the
guide groove is at the back. Other alignments are not permissib-
le, as otherwise the stand can topple over when a unit is moun-
ted on it.
• Set up the stand in a spacious area on an even, stable, clean, non-
slip, dry and fireproof surface.
• Any small unevennesses that cause the stand to rock
must be compensated for with the height-adjustable
feet.
• The T 65 D ULTRA-TURRAX
the guide head of the telescopic stand with the aid of an assis-
tant, and secured with the two screws and toothed lock washers
(supplied), in accordance with the T 65 D ULTRA-TURRAX
rating instructions. The unit must be mounted in front, vertically
above the baseplate; a different alignment is not permissible, as
otherwise the assembly could topple over.
• The overhead stirrer IKA ® RW 47 D must be lifted on to the gui-
de head of the telescopic stand with the aid of an assistant, and
secured with the four screws (supplied), in accordance with the
IKA ® RW 47 D operating instructions. The unit must be moun-
ted in front, vertically above the baseplate; a different alignment
is not permissible, as otherwise the assembly could topple over.
Explication of warning symbols
General hazard
This symbol identifies information that is of vital importance for safeguarding your health and safety.
Disregarding this information can lead to health impairment and injuries.
This symbol identifies information and notes that are of importance for correct handling of the unit.
Safety instructions
dispersion unit must be lifted on to
®
Contents
• This telescopic stand must be fitted with a safety disconnection
device, which stops the unit if the stand is moved upwards when
the unit is operating.
• Switch the unit off before moving the telescopic stand upwards.
• When lowering the telescopic stand, take care that no parts of
the body get between the safety switches (danger of crushing).
• Only switch the unit on when the tool (agitator or dispersion
unit) is in the vessel.
• The handwheel bolt on the stand can come loose due to vibra-
tion, which would lead to the unit moving down. So, check the
tightness of the handwheel bolt regularly when using the unit,
and retighten it if necessary.
• Raise or lower the stand (after slackening the handwheel bolt)
by applying the manual force as close as possible to the stand
pillar. The further the force is applied from the pillar, the more
force you need to apply, plus there is an increased risk of the
equipment toppling over.
• Secure the vessel against spinning round, by using a clamp, for
example.
® ope-
• Beachten Sie die Betriebsanleitung des Dispergiergerätes T 65 D
ULTRA-TURRAX
• Check the appliance and accessories beforehand for damage
each time you use them. Do not use damaged components.
• Protect the appliance and accessories from bumps and impacts.
oder des Rührgerätes IKA
® ®
EN
Page
5
5
6
6
6
7
7
7
7
RW 47 D!
5