Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LubeJet spray gun
You can find further information and instructions from the separate
Operating Instructions for the spray gun, attached.
Safety Instructions
Non-compliance with the safety instructions can result in danger both to persons and to the
environment and the equipment. Non-compliance with the safety instructions can lead to the
loss of any claims for damages. The operator
contents of the Operating Instructions, particularly the Safety Instructions are known to the
operating personal.
The unit must only be operated at the 5 bar set on the pressure regulator.
-
Alterations to the pressure regulator are never permissible, and could lead to damage to the spray
gun.
-
Before any repair or maintenance work, the air connection should be disconnected and the
pressure released from the high pressure hose by operating the trigger on the gun.
F
Never point the spray gun at people or animals! Danger of injury!!
The use of accessory components e.g. hoses and connection fittings, which are not supplied can
-
sometimes give rise to the risk of accidents. No liability can be accepted for accidents or damage
caused by components from other sources.
After using the equipment, relieve the pressure in the hose. Shut off the air feed line and actuate
-
the spray gun again.
Protect hoses from damage and the effects of heat.
-
Replace damaged hoses immediately with genuine spare parts.
-
Modification or alteration to the equipment is only permissible after discussion with the
-
manufacturer.
-
The operational safety of the equipment is only guaranteed if used in accordance with the
directions.
Maintenance, inspection and repairs must only be carried out by qualified specialist personnel,
-
who have acquainted themselves with the subject by studying the operating instructions.
Maintenance:
Make a regular check on the pressure regulator, set at 5 bar.
The equipment must never be operated at a pressure higher than 5 bar.
Make a regular check on the pressurised components for possible damage.
Defective parts must be replaced with genuine spares, without delay.
Please find the instructions for maintenance of the spray gun in the attached separate Operating
Instructions.
Smoothly variable material-
flow regulator
Trigger lock
Smoothly variable adjustment
round jet – wide jet
Trigger
Max. 10 bar G1/4 "
spraying air connection
Max. 250 bar G1/4" material
pressure connection
Special twin hose system
High pressure
-grease hose
Hose protected
with spiral
of the equipment must ensure that the
Compressed air hose
9
Werbung
