Fell Marine WiMEA MOB Benutzerhandbuch Seite 19

Mounting the Boat Unit
1.
2.
3.
NOTICE
4.
5.
6.
7.
8.
9.
Remove the Boat Unit Nut by turning it.
Attach the External Antenna by turning it onto
the antenna connector at the bottom of the
Boat Unit.
Drill a hole in your helm for the Boat Unit. Use
standard 52 mm (2") hole cup drill to make
the hole.
Be sure not to drill through any existing cables or
equipment mounted or situated on the backside
of your intended Boat Unit position!
Insert the Boat Unit Cable and External
Antenna into the hole and then place the Boat
Unit in the hole.
Place the gasket between the flange under the
top of the Boat Unit and the surface of the
helm/wall surrounding the hole.
When positioning the Boat Unit in the helm
or other suitable place, make sure to set the
direction of the Boat Unit with the battery
indicator at 12 o'clock and the FELL printing
at six o'clock.
Tighten the Boat Unit Nut from behind to
securely attach the Boat Unit in the helm. The
Boat Unit Nut is fitted by applying normal
hand force.
Attach the Boat Unit Cable and the Connection
Cable by connecting the male and female
5-Pin Connectors together on the two cables.
Proceed to connecting the wires, see page 21
"Connecting the wires".
19