rodger clippo Gebrauchsanleitung Seite 4

To test the sound, put the "test device" in the
mouth of the sensorclip. This will cause the
alarm to sound. (In case you ordered the op onal
pantsconnector, connect the two push-bu ons of
the pantsconnector with the "test device").
Op on 2: For every alarm to be a diff erent sound >
set switch (E) to 8;
With every alarm 1 of the 8 available sounds will sound.
• Se ng volume (remove ba ery cover):
Select the desired volume with switch (F).
Manual instruc on pictograms
See inside cover for an overview of the instruc on pictograms belonging to
the explana ons below.
1. Connect the cable to the bedwe ng alarm.
2. Clip the alarm with the magne c clip to the shoulder area of the pajama
top.
3. A ach the sensorclip to the outside of the pants.
4. Sleep well.
5. The alarm will sound when urina on occurs.
6. Get up, remove the clip from the pants, turn off the alarm and go to the
toilet.
7. Repeat steps 2 and 3 with a clean pants, sleep well.
8. Wake up dry!!!
Remarks
• A ach the sensorclip in the area that the fi rst drops of urine would
appear (see fi gure).
• Let the cable run inside the pajama top.
• Only removing the clip will not stop the alarm.
• Clean the sensorclip regularly. You can do this by using a li le soapy water
on a cloth. Rinse a erwards with clean water and dry.
4