Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Calibrate
1.Get both transmitter and aircraft prepared.
2. Place the drone . Turn on it ,And the lights flash slowly.
3. Turn on the transmitter . The transmitter
flashes slowly and beeps twice.
4.Turn on the transmitter, push up and down the left control
stick,when the light was not shinning, it indicates the connection
has finished.
Important tips: During the calibration, if the place where
you place the aircraft is not flat (or it tilts), the following
flight would be hard to control.
Inspection
1. The main light in the drone points to the front.
2. If the aircraft deviates to one side during flight, it is
allowed to make adjustment through the fine tuning of
the remote control.
3. After the aircraft takes off, when it is not able to use a
fine tuning to correct and the aircraft hovers, which makes
it difficult to control, please re-calibrate the aircraft.
Note: when an aircraft receives a violent impact or an
abnormal fall, the gyroscope may not be reset, thus
making it difficult to control. At this time, it is necessary
to power on again and calibrate the aircraft.
Werbung
Inhaltsverzeichnis
