the t.bone SCT-800 Einleitung Seite 2

the t.bone SCT-800 stereoset
Quick start guide:
1. Connect the microphone to the
power supply with the 7pin XLR
cable.
2. Connect the power supply audio
output to your mixer. Take care,
that phantom power is switched off.
3. Connect the power supply to an AC
outlet and switch it on.
4. Allow the microphone to warm up
its tube for at least 10 minutes
before use.
Diagrams:
Contact:
Musikhaus Thomann
Treppendorf 30
96138 Burgebarch
Germany
Tel.: +49-9546-9223-0
Fax.: +49-09546-6774
Web: www.thomann.de
E-Mail: info@thomann.de
Suggestions?: qs@thomann.de
Introduction:
Thank you for purchasing the
We'd like to thank you for your confidence in the product and
hope that you will enjoy your new microphones.
The SCT-800 stereoset consists of two matched SCT-800
microphones. They have the same serial number to ensure that
they never separate.
Warning:
Never remove the screen holding the capsule, as this can
damage the microphone!
Caution:
Do not drop your microphone! This can cause severe damages!
Maintenance and cleaning:
When the microphone is not in use, take it out of its shock mount
and place it in its case.
Clean with wet cloth only.
Specifications:
Type:
Frequency response:
Polar Pattern:
Sensitivity:
Output impedance:
Equivalent noise level:
Max. SPL (@0,5% THD): 125dB
Power:
Audio connection:
SCT-800 stereoset.
large diaphragm condenser,
with vacuum tube
20Hz to 20kHz
cardioid
14mV/Pa (@1kHz, 74dB SPL)
<200 ohms
<17dB-A
external power supply unit
3-pin XLR
Specifications subject to change without notice!