Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Install the device on a plane surface.
During operation of the device, liquid may form around the machine.
The liquid container (rather, sponge) of the device needs to be filled with fragrance before starting up
operation and always disconnected from the mains as fluid could be spilled.
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.
With the POWER-switch, you can switch the device on and off.
Procedure:
Step 1: Unscrew the fixation screws of the service lid on top of the housing.
Step 2: Remove the service lid.
Step 3: Remove the dry sponge from the liquid container and soak it in a fragrance of your choice. The
sponge should not drip, however!
Step 4: Insert the moist sponge into the liquid container.
Step 5: Replace the service lid and tighten the screws.
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Do not operate this device with opened service lid!
International
L
N
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
11/22
51706010_V_1_0.DOC
Werbung
Inhaltsverzeichnis
