Herunterladen Diese Seite drucken

Zublin 3326 Installationsanleitung

Rc löschglied
RC Löschglied
Edition 4-2017
Art.-Nr. 3326
RC Unit
EN
RC Löschglied
DE
Circuit RC d'extinction
FR
Circuito di soppressione RC (snubber RC)
IT
Układ gaszący RC
PL
The crossed-out wheeled dust bin symbol indicates that products must be collected and disposed of separately from household waste.
EN
Use an official collecting point or contact your retailer where the product was purchased.
Die durchgestrichene Mülltonne weist darauf hin, dass das Produkt vom Hausmüll getrennt entsorgt werden muss.
DE
Benutzen Sie eine offizielle Sammelstelle, oder geben Sie das Gerät dem Händler zurück, bei welchem das Produkt gekauft wurde.
La poubelle barrée d'une croix indique que le produit doit être traité séparément des déchets ménagères.
FR
Utilisez un point officiel du recyclage, ou retournez l'appareil a votre revendeur auprès duquel le produit a été acheté.
Il contenitore barrato indica che il prodotto deve essere smaltito separatamente dai rifiuti domestici.
IT
Utilizzare un punto ufficiale di riciclaggio o restituire l'unità al rivenditore dove è stato acquistato il prodotto.
Przekreślony kontener na kółkach oznacza, że produktu nie należy wyrzucać razem z odpadami komunalnymi.
PL
Użyj specjalnego punktu recyklingu lub zwrócić urządzenie do sprzedawcy, u którego został zakupiony produkt.
Neue Winterthurerstr. 30, CH-8304 Wallisellen
Marie-Curie-Strasse 2, DE-79618 Rheinfelden-Herten
M. Züblin AG
www.zublin.ch
Züblin Elektro GmbH
www.zublin.de
loading

Inhaltszusammenfassung für Zublin 3326

  • Seite 1 Züblin Elektro GmbH Marie-Curie-Strasse 2, DE-79618 Rheinfelden-Herten www.zublin.de RC Löschglied Edition 4-2017 Art.-Nr. 3326 RC Unit RC Löschglied Circuit RC d’extinction Circuito di soppressione RC (snubber RC) Układ gaszący RC The crossed-out wheeled dust bin symbol indicates that products must be collected and disposed of separately from household waste.
  • Seite 2 INSTALLATION INSTRUCTIONS Install the RC-Unit always close to the sensor 1. Interference-voltage cause of inductive ballast option loads RC between L’ and N. 2. Induced voltage on R (Push-button-input does not work properly) RC between R and N. L’ 3. Induced voltage on S (Slave-input does not Master work properly) RC between S and N.