Maintenance And Care; Disposal Information - Flex MXE 18.0-EC Originalbetriebsanleitung

MXE 18.0-EC
Operating instructions
 After it has been switched off, the mixer
runs on for a short time.
 If the rotating mixer paddle strikes
a surface, it could cause a jolt.
 Only switch on the tool after the mixer
paddle has been immersed in the
product to be mixed. When doing this,
slowly press the switch and wait until the
tool has reached maximum speed.
 When taking a break from work, place the
tool down on the rests.
Overload protection
NOTE
In the event of overload or overheating in
non-stop operation, the power tool will
switch off.
To continue working, switch the power tool
off and back on again
For further information on the manufacturer's
products go to www.flex-tools.com.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
 Regularly clean the power tool and
ventilation slots.
 Regularly blow out the housing interior
and motor with dry compressed air.
 Clean the mixer paddle straight after use.
Do not allow the mixed product to dry on.
Charger
WARNING!
Before performing any work on the charger,
pull out the mains plug. Do not use water or
liquid detergents.
 Remove dirt and dust from the housing
with a brush or a dry cloth.
Gear
NOTE
Do not loosen the screws on the gear head
during the warranty period. Failure to comply
with this requirement will invalidate any
claims under the manufacturer's warranty.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
Mixer paddles for different applications and
other accessories can be gleaned from
the manufacturer's catalogues.
Exploded drawings and sparepart lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
–
the power cord,
battery operated power tool by removing
–
the battery.
EU countries only.
Do not dispose of electric power tools
in the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and its incorporation
into national law, used power tools must be
collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should be
recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
17