Werbung
!
Ending Calls
While a call is in session on the Headset, pressing S1 will disconnect the call. After
the call is disconnected, the green LED will flash normally.
!
To make a new call using voice dialing
When using a Bluetooth mobile phone:
1.Make sure the voice dialing function is probably set up in the Mobile phone and it is
within the range of the HS. Press S1 on the HS shortly.
2.After the beep tone on the HS, make a voice dial as you normally would by saying
the name of the person on the HS. The call will be connected in a few seconds.
When using a mobile phone without Bluetooth built-in and requiring a Bluetooth
dongle:
1.Make sure the voice dialing function is probably set up in the mobile phone and it is
within the range of the HS. Press S1 on the HS shortly.
2.After the beep tone on the mobile phone, make a voice dial as you normally would
and the call will be connected in a few seconds.
!
Redialing last dialed number
(Support handsfree profile mobile only. For Nokia
3650, Siemens S55, or equivalent models)
To redial the last dialed number, press and hold S3 for 2 seconds. Short low tones
will indicate an attempt to redial.
!
Rejecting incoming call
(Support handsfree profile mobile only. For Nokia 3650,
Siemens S55, or equivalent models)
When there is an incoming call and you want to reject it, press the buttons S1 and
hold it until you hear a long beep tone, then release it.
!
Adjusting Speaker Volume
While a call is in session, pressing and releasing S2 will increase the speaker
volume; pressing and releasing S3 will decrease the speaker volume on the HS.
There is a key tone to indicate volume increase or decrease. However, a warning
tone will be heard when the volume level reaches its maximum or minimum.
! Right or left ear
If you want to wear the
HS
on your right ear, you have to change the orientation of
the ear hook.
Left ear orientation
Right ear orientation
1) Pull the ear hook upward from
2) Put the ear hook back to the
the knuckle joint and flip the
knuckle joint and pull it down
hook 180 degrees.
firmly.
8
! Bend the ear hook to fit
Warning
your ear
Don't pull the ear hook side way over its
limit, it will break the ear hook joint.
! Putting way
1
1. Put on the headset with the ear hook behind your ear.
2. Bend the ear hook gently to fit your ear.
Notice: Make sure the microphone is pointing towards your mouth.
!
Low-battery indication
The HS LED will flash red instead of green when the battery is low.
There will also be a short beep every few minutes. When the battery level is too
low, the HS will automatically power off. It cannot be powered on again unless the
charger is connected.
!
Charging and recharging the battery
To recharge the battery, connect the charger cable to the HS. During recharging,
the LED shows a steady red light.When the battery is fully charged, the indicators
of red will be off.
DISCLAIMER: Talk time and stand-by time of the Abe
CS8084
Bluetooth
Headset will vary
depending on mobile phone model being used
9
! Charging Connection
(1) A/C charging
ins
AC Ma
ptor
AC Ada
:
NOTE
,
.
BQB
CE and FCC approved
Bluetooth
Abe UB 20S USB
Dongle and Abe CS8084
Voice Over Internet Protocol (VOIP) Application
Plug the Abe UB 20S USB
Bluetooth
Dongle (purchased separately) into the USB
1.
socket of a PC.
2.
Install IVT BlueSoleil
Bluetooth
application from the CD-ROM provided in the UB 20S
package. Note that the CD-ROM is not available in the CS8084 package.
3.
Download from the corresponding websites and install MSN messenger, Netmeeting,
Yahoo messenger, or ICQ application software in the PC.
Pairing: Put the
Abe
CS8084
Bluetooth
Headset into "pairing" mode by following the
4.
steps in the CS8084 User Manual, start the BlueSoleil application and pair the UB 20S
Dongle with the CS8084 Headset. The Headset passkey is "0000
5.
Connecting and Disconnecting: The UB 20S Dongle will ring the CS8084 Headset.
Please press the S1 key on the headset to confirm the connection request.
disconnect the
Bluetooth
link, press the S1 key again.
reconnect your CS8084 Headset to your
Bluetooth
6.
Testing the
Bluetooth
Link: After the UB 20S Dongle is paired with the CS8084
Headset, the PC audio will be automatically routed to the
Play some music on the PC by Windows Media Player or other music applications; you
should be able to hear the music on the Headset. If you can hear it, then go the
"c
ontrol Panel ->
"
"S
ound and Audio Device Properties ->
select the
"
B
luetooth
Audio to activate the link.
"
7.
Now you can start using the VOIP application and talk to your friend through your
headset wirelessly and freely.
Connecting CS8084
Bluetooth
Headset back to your
8.
follow the steps from 'Putting Headset in Pairing Mode' to Establishing
on page 7.
10
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
2
cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions
for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
11
Bluetooth
Headset
".
To
You can now pair and
mobile phone, if you desire.
"
B
luetooth
Audio driver.
"
't
"
"A
udio ->
"
"S
ound playback
"
Bluetooth
mobile phone. Please
'
Bluetooth
Link'
12
Werbung
