Setting The Cutting Height; Setting The Front Wheels; Setting The Rear Wheels - Medion MD 16906 Originalbetriebsanleitung

7. Setting the cutting height

You can use the adjusting wheel to set three cutting heights: 20 mm, 40 mm or
60 mm.
DANGER!
Risk of injury.
 Adjust the cutting height only when the appliance
is switched off and unplugged. Make sure that the
blade has come to a complete standstill.
NOTICE
 To ensure an even cut and a steady ride for the
appliance, make sure that all wheels are set to the
same position.

7.1. Setting the front wheels

 Pull the front wheel axle with both thumbs to the
front and set it in the desired locking position by
letting the wheel axle go again.
Cut length:
− Upper position: 60 mm
− Middle position: 40 mm
− Lower position: 20 mm

7.2. Setting the rear wheels

 Lift the wheel axle slightly on the free side. At
the same time, push the opposite wheel to the
desired position I–III.
Cut length:
− Position I, top: 60 mm
− Position II, middle: 40 mm
− Position III, bottom: 20 mm
DE
FR
NL
EN
87 of 98