Troubleshooting - Axis T8134 Installationshandbuch

NO TICE TICE
NO NO TICE
• Keep the midspan away from excessive heat and humidity and
free from vibration and dust.
• Ensure that the cable length from Etherhet network source to
the terminal does not exceed 100 m (330 ft). The PoE is not a
repeater and does not amplify the Ethernet data signal.
• If a splitter is to be used, make sure it is connected close to the
terminal and not on the midspan.
• No ON-OFF switch exists, simply plug the midspan into an AC
power source.
• Ensure that all network cables used in the installation are STP
and Category 5/5e/6.
• Do not use countersunk screws when mounting the midspan.
Screw size 4 mm.

Troubleshooting

AXIS T8134 does not power up
• Remove and re-apply power to the device and check the
indicators during power up sequence.
• Verify that the voltage at the power inlet is between
100 — 240 V AC.
• Verify that the power inlet cable is functional.
The powered device does not operate
• Verify that the powered device is designed for PoE operation.
• Verify that a standard Category 5/5e/6, straight-wired cable
with four pairs is used.
• Verify that the input Ethernet cable is connected to the
DATA IN port.
• Verify that the powered device is connected to the
DATA & POWER OUT port.
AXIS T8134 Midspan 60W
13