Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Installing the Cosidrum
Get your cosidrum carefully from its packaging. Select the location for your Cosidrum. The location must meet
the following conditions:
-
Make sure that the Cosidrum is placed on a paved (preferably stone) surface. The surface should be
completely flat and clean
-
The Cosidrum should be placed at least two meters away from flammable materials and liquids.
The Cosidrum consists out of two parts, namely the bottom and the top. First, place only the bottom and make
sure it is 100% stable state, and then gently place the top of the device. (see point 2: Placing the gasbottle)
Rotate the top of the Cosidrum and gently place it with the top down. Before Cosidrum is ready for use you
should place an AA battery for the piezo ignition.
If the Cosidrum is installed properly, you can place lava rocks and ceramic logs on the top. Grab first the small
lava stones and place them on the ground. Every Cosi fires is deliverd with 1.5kg small lava stones and 1.5kg
large lava rocks included. Take the small lava stones without grit and place it gently on the lid. Repeat the same
with the big lava stones and make sure it is covered with lava rocks. Make sure you keep the ignition unit free
Gebruiks- en montagehandleiding sistrum / Operating and assembly instructions cosidrum / manuel de montage et mode démploi cosidrum
of lava stones
(see picture). After placing the lava rocks,get the ceramic logs
out of the packaging. The Cosidrum is always included with four ceramic
logs. The ceramic logs insert a campfire in the fire ring back. Make sure the
fire ring is minimal covered by the logs. When the logs block the fire ring,
there will be a dangerous situaties. The blockade of the fire ring will affect
the air flow of the ring and the flames will be different. This results in
dangerous situations!
If you want to reorder the lava stones or ceramic logs, this is possible with
Gimeg. Use the following part numbers:
-
5950150. Small lava stones
-
5950160. Large lava stones
-
5950170. Four ceramic logs.
When you are going to use the Cosidrum for the first time, make sure that
the device is turned at the highest setting for 15 minutes. In this way, the
lava stones are heated through and this ensures that any bumps or air
bubbles will disappear from the lava rocks
When you want to move or cleanup the lava stones and ceramic logs, make
always sure that they have cooled down completely.
The lava rocks and logs can be scorching black in time. This has to do with
soot formation which always occurs in devices which show a yellow flame.
This soot can be removed by blowing / vacuuming with a vacuum cleaner.
The carbon black may be also brushed off with a dry brush.
13
Werbung
