Inhaltsverzeichnis; What's In The Box; Connections - Teac LS-X55 Bedienungsanleitung

Contents
Thank you for choosing TEAC.
Read this manual carefully to get the best performance from
this unit.
What's in the box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

What's in the box

Check to be sure the box includes all the parts shown below .
Speaker (LS-X55) x 2
Wall mount bracket x 2
Jointing bolt x 4
Owner's manual (this document) x 1
Warranty card x 1
o The wall mount brackets and the jointing bolts are attached to
the speakers when you unpack the box . Remove them before
installing the speakers .
o Keep this manual for future reference .
2

Connections

Connect the speaker terminals to the amplifier terminals using
commercially available speaker cables .
CAUTION
To avoid damaging the speakers with a sudden high-level signal,
be sure to turn off the amplifier before connecting the
speakers .
Right speaker
Strip off the insulation from the ends of the cable and twist
1
the bare strands together to facilitate connections.
While pressing the lever, insert the end of the cable to the
2
terminal, and then release the lever.
Connect the left channel of the amplifier to the left speaker, and
the right channel of the amplifier to the right speaker .
Also make sure to connect:
¥ red terminal of the speaker
e ¥ terminal of the amplifier
Using ¥ side of the speaker cable
^ black terminal of the speaker
e ^ terminal of the amplifier
Using ^ side of the speaker cable
o Do not insert the insulation coating into the terminal . Insert only
bare wire .
o Make sure it is fastened securely by pulling the cable lightly .
o Read the instructions of the amplifier carefully .
o The maximum rated input signal to the speaker is 80 W per
channel . When connecting to an amplifier having an output
higher than 80 W, be careful not to overpower the speaker with
excessively high volume as this will damage the speaker .
Left speaker
Ampli er