Werbung
Verfügbare Sprachen
Verfügbare Sprachen
01 SCOPE OF DELIVERY
en
1 x Microfly 2.0 drone
4 x extra blades
1 x Remote control (2,4 GHz)
4 x blade protection
1 x USB charging cable
1 x mini screwdriver
1 x user manual
red LEDs
USB charging cable
MICROFLY 2.0 (X1)
User Manual
Suitable age: More than 14 years old
4 extra blades
02 IMPORTANT SAFEGUARDS
› This product is a high speed aircraft. Improper use may cause
damage to people or property. Therefore, the user must be aware
of people or property while using the drone.
› Do not touch the running propellers - keep hands, hair and loose
clothes away from moving parts to avoid injury.
› Never allow young children to use this product without adult
This manual contains important safety and operating instructions.
supervision (manufacturers and dealers disclaim all responsibility
Before using the product, read all instructions and cautionary markings
for damage caused by misuse).
on product carefully. Save this Manual for future reference or other users.
› DO NOT expose the drone to rain, moisture or snow.
13 DECLARATION OF CONFORMITY
› DO NOT operate the drone if it has received a sharp blow,
Hereby ZOGI / Herzog Products GmbH declares that this product
been dropped, or otherwise damaged in any way, take it to a
complies with the legal EU regulations, standards and guidelines at
qualified service person.
the time of purchase.The Declaration of Conformity can be found
› DO NOT disassemble the drone. Take to a qualified service
under the following URL:
person when service or repair is required.
https://zogi.biz/wp-content/uploads/2017/09/conf-microfly.pdf
04 CALIBRATION:
› DO NOT use under water or immerse in water.
en
en
› This item is not a toy. Keep out of reach of children.
GYROSCOPE CALIBRATION:
› The factory and retailers will not be liable for any compensation or
legal liability resulting from accidental injury.
03 CHARGING
Pushing the left joystick and right joystick to the left corner at the
Important: During the charging process, the product is heated,
same time, the calibration is successful once the light stops flashing.
this is normal. If you find that the product is extremely hot ,
When the drone drifts any direction, and the fine-tuning adjustment
disconnect the power supply and do not use it anymore. Risk of
is not the reason for it, this operation can repair it.
injury by escaping gases, liquid or explosion.
On/Off
COMPASS CALIBRATION:
blue LEDs
Battery
› Charge the the drone fully before first use.
› Insert USB charging cable in the USB port of a computer or any
Pushing the left joystick and right joystick to the right corner at the
compatible 5 V USB connection.
same time, the calibration is successful once the light stop flashing.
› Connect the battery plug to the USB charging wire. The LED
05 HANDLING AND TAKING OFF
indicator on the USB cable is turning on now, indicating charging.
When it is turning off, it is fully charged.
› Charging time is about 45 minutes.
BATTERY
› Put the battery into the battery box.
› Put the battery plug into the socket of the drone.
Fine-adjustment of turning left/right
The left control lever (throttle/steering)
LEDs
TAKING OFF THE DRONE:
en
en
› Power on the drone and the remote control.
› Push the left control lever up and down.
› The LEDs of the drone will stop flashing.
› Push the left control lever slowly up to take off the drone.
The right control lever controls leftward/rightward flying.
› Push the left control lever slowly down to land the drone.
NOTE:
When the navigation light of the drone begins to flash, it indicates
that the battery is low. At this moment you should land the drone to
prevent the drone from falling down and eventually causing damage
NOTE:
to people or property.
Use the remote control carefully to not lose control of the drone.
FINE-TUNING
06 CONTROL
If the drone encounters offset in the flying (rotation; forward or
backward; leftward or rightward), click the corresponding fine tuning
button on the remote control in reverse direction for the adjustment.
For example: the drone has forward deviation, click „forward/back-
ward fine-tuning" key to adjust as shown below.
The left control lever controls up/down.
fine-adjustment of
forward/backward
The right control lever
(forward/backward/
The left control lever controls leftward/rightward rotation.
left and right side fly)
Flip (short press)
Fine-adjustment of
left/right side fly
The right control lever controls forward/ backward.
09 DISPOSAL
LOOPING
en
en
The drone can take a 360-degree flip. For better performance ensure
Electrical and electronic equipment must not be disposed of with
that the drone is flying three meters above the ground.
household waste, but must be returned to a public separate collecti-
The best is to flip the drone during the process of rising, because after
on or at the point of sale.
flipping the drone, it's easier to maintain height.
› Press shortly on the right control lever. Than move it to your desired
For more information, please contact your sales outlet or the public
direction and back to the middle position (move to the right to flip
authorities. When you dispose of the packaging, pay attention to the
it right, front to flip front, etc)
relevant regulations in your country.
07 INSTALLATION AND DISASSEMBLY OF BLADE
10 SPECIFICATIONS
The blades of the drone have to be in a certain position. Each blade
Battery:
LiPo-Akku; 150 mAh; 3,7 V; 0,56 Wh
is marked with „A" or „B". When installing the blades, please correctly
Input:
5 V DC; 500 mA
install as shown below. When the blade is not properly installed, the
Remote Control: 2,4 GHz
drone will be unable to take off, or will rollover or fall down.
08 TROUBLESHOOTING
› The propeller does not rotate or reacts very slowly.
› Land the drone. After a pause for three seconds, take off again.
You may also try to reconnect the drone or charge the battery.
› The drone in flight is shaking or vibrating with great noise.
› Check whether the motor, the case or blades are installed correctly.
› The blades cannot rotate or the drone can't take off.
Herzog Products GmbH
› Check whether the blades are installed correctly.
Gutenbergstraße 2
› Drone doesn't flip.
75210 Keltern, Germany
› Check if the battery is charged.
WWW.ZOGI.BIZ
en
Made in China
Werbung
