Electrical Connection; Assembling The Power Plug (Optional) - WITA UPH 20-KS Original Einbau- Und Betriebsanleitung

Operating instrutions

9 Electrical connection

Warning: Risk of death!
Improper installation and improper electrical connection can present a fatal hazard.
Hazards posed by electrical power must be eliminated.
• Only have installation and electrical connection performed by a specialist and
in line with the valid regulations (e.g. IEC, VDE, etc.)!
• The current type and voltage must correspond with the information on the type plate.
• Observe the specifications of local energy supplier!
• Observe accident prevention regulations!
• Never pull on the power cable
• Do not bend the cable
• Do not place any objects on the cable
• When using the pump in systems at temperatures over 90 °C, use a connection
line that is suitably heat resistant.
• Hazards such as sharp edges and burrs arise during installation.
• When transporting the pump, never hold it by the power cable.
• The pump could cause an injury if it falls.
9.1

Assembling the power plug (optional)

Connect the power cable to the pump as shown.
Caution: Line voltage! Observe the required protective measures, national body regulations and
local provisions at all times. The cable cross-section may no smaller than 0.75 mm2. Use ferrules
if using fine-wire cables.
26
WITA UPH 15 | UPH 20-KS
1
2
3
2
Click
4
1
Click