Komfovent DOMEKT REGO 400VE-B Installations- Und Bedienungsanleitungen Seite 22

EN
Disconnect fans' connections; pull out air temperature sensor together with a rubber plug. Loosen all wires fixed
in the partitions with rubber gaskets and extract rotary heat exchanger (9 Picture).
pull
disconnect
While unit casing is disassembled, all protective gaskets from the unit back side must be removed on its front one
(10 Picture). Then assemble in inverse way to get the unit of opposite inspection side.
Before inserting rotary heat exchanger, one by-pass cover which is located in it must be removed. Cover is un-
screwed with six screws. This is done to have correct by-pass air flow direction. Opened vent must always be
near exhaust flow fan (11 Picture).
Note: There are two by-pass covers by default. When connecting the by-pass, one cover must be removed.
22
UAB AMALVA we reserve the right to make changes without prior notice
9 Picture
10 Picture
11 Picture