Software Update; Problem Solving - favero Console-700 Benutzerhandbuch

ENGLISH
8. brown
7. white-brown
6. blue
5. white-blue
4. orange
3. white-orange
2. green
1. white-green
3. S
OFTWARE UPDATE
In the product page at www.favero.com, you will find the last available software version. To update the software,
please follow the instructions below:
1) download the zip file of the new software from the Favero website;
2) extract all the files in the zip file and copy them in the root of an USB memory pen;
3) make sure that the console battery is fully charged;
4) unplug the battery charger and turn off the console;
5) insert the USB pen on the USB connector you find on the back (see Fig.2.1);
6) press and keep pressed the "ON-OFF" button until you hear 3 consecutive beeps;
7) the console will update its own software and at the end, it will display the initial screen where you will be able to
verify that the firmware version is the one desired.
4. P
ROBLEM SOLVING
This chapter contains information on the main problems which may occur during the product's life. Its purpose
is to help you quickly solve them.
If during the use of the product, you encounter a problem which is not indicated in this manual, please describe it
in detail and send an email to support@favero.com.
4.1. The console does not switch on
The battery charge might be too low. Make sure the power supply unit voltage is 9V and then connect it to
Console-700.
4.2. The battery does not charge
Make sure the battery charger voltage is 9V, otherwise order a new one (art.308-20).
4.3. The console does not switch off
Keep the ON/OFF button pressed for at least 5 seconds, until the Console-700 switches off.
4.4. The brightness of the display is too low
In the Configuration menu, select the "SYSTEM SETTINGS" tab; then increase the "Brightness of the console
display" parameter.
4.5. The scoreboard horns make no sound
In the Configuration menu, select the "SPORT" tab; then make sure that the "Sound at the end of game"
parameter is higher than zero. Then check that the "Horn volume" parameter in the "SYSTEM SETTINGS" menu
is higher than zero.
4.6. The touchscreen buttons are not correctly detected
The touchscreen must be calibrated: in the Configuration menu, select the "SYSTEM SETTINGS" tab and the
"Touchscreen calibration..." parameter. Then carry out the operations prompted on the screen.
00308-M01-03-ML - Console-700 User Manual
Fig. 2.5: Network connectors wiring (RJ-45)
8 / 44
1. white-green
2. green
3. white-orange
4. orange
5. white-blue
6. blue
7. white-brown
8. brown
F E
AVERO LECTRONICS SRL