Troubleshooting; Safety Precautions - BasicXL BXL-INV100W-12 Anleitung

Troubleshooting

If the inverter does not function properly, there can be several possible reasons for it:
1) Poor contact.
• Clean contact parts thoroughly.
2) Inverter has no power.
• Check car fuse, replace blown fuse.
• Check connection of wires.
3) Fuse is blown.
• The fuse is located in the DC (cigarette) plug. Replace the fuse with a similar
fuse of equivalent value.
4) AC output shutdown caused by overload.
• Make sure the continuous load of the attached appliances does not exceed
100 Watts.
5) AC output shutdown caused by overheating.
• Under heavy loads for extended periods of time, the inverter will shut down the
output to prevent damage from excess heat. If this happens, please proceed
as below:
(A) Switch off the power switch of the inverter.
(B) Decrease the load of the machine i.e. disconnect some of the appliances
or wait until this inverter cools down.
(C) Switch on the power switch of the inverter.
6) Low-battery shutdown.
• Recharge your battery and resume operation.
Caution!
Always place the inverter in an environment that is:
1. well ventilated,
2. not exposed to direct sunlight or heat sources,
3. out of reach of children,
4. away from water, moisture, oil or grease,
5. away from any inflammable substances.

Safety precautions:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
mains and other equipment if a problem should occur. Do not expose the product to
water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the
product or damage caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of
their respective holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and
electronic products should not be mixed with general household waste. There
is a separate collections system for these products.
To reduce risk of electric shock, this product should
ONLY be opened by an authorized technician when
service is required. Disconnect the product from
3