Technical Specifications - Velleman GASIRON2 Bedienungsanleitung

 The soldering head (#1 to 4) can be screwed off by turning the locking ring (#4) counter clockwise.
 When working with the soldering head installed, make sure the locking ring is well fastened and the exhaust
vent (#2) faces up; if the exhaust vent faces down, it may damage the surface underneath what you are
soldering.
 The soldering tip itself (#1) can also be removed by screwing it off.
7. Operation
7.1 Soldering Iron
1. Make sure the exhaust vent (#2) faces up.
2. Set the on/off switch (#6) to the ON position to let the gas flow.
3. Pull the soldering head forward until you can see the nozzle (#10) through the ignition vent (#3). Then
light the gas by bringing an open flame to the ignition vent.
4. Release the soldering head; the flame will disappear inside the head and will generate heat there.
5. Set the on/off switch (#6) to OFF to extinguish the soldering iron.
7.2 Gas Torch
1. Remove the soldering head (#1 to 4).
2. Set the on/off switch (#6) to ON to let the gas flow and bring an open flame next to the nozzle (#10).
3. Set the on/off switch (#6) to OFF to extinguish the soldering iron.
7.3 Hot Blower
Screw the soldering tip (#1) off the soldering head by turning it counter clockwise. Ignition and extinguishing is
the same as for the soldering iron (§4a).
7.4 Flame / Heat Adjustment
Adjust the gas flow by means of the gas volume control (#7). Rotate it to the + or the - to increase or decrease
the gas flow.
7.5 Refilling the Gas Tank
1. Make sure the on/off switch (#6) is set to OFF and the GASIRON2 has cooled down completely.
2. Refill the device in a well-ventilated area away from any ignition source and away from other people. Do
not smoke while refilling the gas torch.
3. Refill with butane gas only.
4. Hold the GASIRON2 upside down, insert the nozzle of the butane canister into the gas refill valve and
press the canister down to let the gas flow from the canister into the gas tank of the soldering iron.
5. When the gas stops flowing, pull the canister out of the refill valve.
8.

Technical Specifications

autonomy .......................................................................................... 40 min. (average use)
temperature ................................................................................................... max. 450 °C
spare bit .................................................................................................... GASIRON2/SPB
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 02 – 26/08/2016
GASIRON2
4 ©Velleman nv