Palmer PEOCT Bedienungsanleitung Seite 5

INSTALLATION & OPERATING:
PALMER OCTOBUS OPERATING INSTRUCTIONS
FEATURES
- 32 programmable preset groups
- True Bypass switching
- Fast, Low-noise switching
- Sturdy construction
SETUP - CONNECTING THE UNIT
- Connect your instrument to the input of the Octobus
- Connect the pedals (up to 8 units) to the loops of the Octobus L1-L8.
Connect the pedal input to the send of the Octobus und the pedal output
to the return of the Octobus.
- Connect the output of the Octobus to your amplifier
- Connect the supplied 9V DC adaptor to the DI in of the unit.
- Switch on all the effects
TRUE BYPASS.
The Octobus always powers up in true bypass mode. The bypass is on when
the ABCD LEDs and the L1-L8 LEDs are flashing. In this mode all the ef-
fects are bypassed and the input is routed directly to the output. To
exit the Bypass mode press any of the switches ABCD.
To turn the bypass on, either:
- Press the preset that is currently activated again (Switches ABCD)
- Double-press any of the non-active preset switches (switches ABCD)
PROGRAMMING THE OCTOBUS
The footswitches "ABCD" are used to save 4 user preset combinations of
effects for instant recall. The "Bank +/-" footswitches are used to
scroll between the 8 different banks (each containing 4 presets).
Example setup:
Lets say you have connected 8 effects to the Octobus. Now you only want
the effects L1, L3, L6 and L8 to be active in one particular preset. You
want this configuration to be stored in Preset A of Bank 1
Proceed as follows:
1) Press Bank "+" or "-" to navigate to bank 1 ("1" is shown on the nu-
meric display)
2) Press the footswitch "A", you are now in Bank 1, Preset A.
3) Press the red "EDIT" button on the Octobus. An "L" will appear on the
display. L stands for low – this means you can now edit the lower 4 loops
(Loops 1 to 4).
4) The ABCD switcher are now assigned to the Loops L1-L4 correspondingly.
In this example press A and C to activate the Loops L1 and L3. The LEDs
indicate if a loop is active or not.
5) Press Bank "-" until the letter H appears in the display. Now the
5