SEVERIN BR 7953 Gebrauchsanweisung Seite 10

hold the plug in your hand to prevent
damage or injury while the cord is
retracted.
Accessories
The crevice and upholstery tools are
conveniently stored in the integral accessory
compartment
Simply press the compartment release to
open the compartment.
Multi-purpose tool
The multi-purpose tool is especially suitable
for cleaning large areas. It can be adjusted
for use on tile floors or carpeted floors by
means of the lever on the attachment top.
Crevice tool
The crevice tool is designed to clean difficult-
to-reach areas such as grooves, niches,
corners and crevices.
Upholstery brush
Fold out the brush element of the crevice
tool in the direction indicated by the arrow
until it locks into place.
The brush tool is suitable for cleaning
uneven areas such as upholstered surfaces,
picture frames, rows of books etc.
Models with parquet-brush
The parquet brush is used for high-grade
hard floors such as laminate floors, parquet
or ceramic tiles.
Changing the dust bag or filters
●
Before any filter is changed, always
switch the appliance off and remove the
plug from the wall socket.
The vacuum cleaner uses replaceable filters.
When replacing the motor protection filter,
it may be necessary to cut the filter to size
with a pair of scissors.
The indicator shows when the dust bag
needs changing: as soon as the indicator
shows permanent red, the appliance must be
switched off and the dust bag replaced.
A noticeable decrease in vacuuming power
also indicates that the dust bag has reached
its capacity.
Changing the dust bag
- Remove the hose by pressing the two
buttons at its end.
- Push the filter compartment release
inwards to open the compartment.
- Lift out the filter holder with the dust bag
attached.
- Pull the full dust bag from the filter
holder.
- Fit the cardboard frame of the new dust
bag into the filter holder.
- Insert the filter holder with the new bag
into the filter compartment.
- Close the cover of the filter compartment
by pressing it down lightly until it is heard
clicking into place. The cover can only be
closed with a dust bag inserted.
Changing the motor protection filter
The motor protection filter is located at the
rear of the filter compartment. Should the
filter be visibly dirty, replacement is
recommended at the same time as the dust
bag is changed.
- Lift out the old motor-protection filter
from the filter holder.
- Insert a new motor protection filter into
the bracket.
Changing the Hepa-filter
This filter is located in the Hepa-Filter
compartment. Should the filter be visibly
dirty, replacement is recommended at the
same time as the dust bag is changed.
- Press the release button for the Hepa-
filter and remove the compartment lid.
- Remove the old Hepa-filter.
- Fit a new Hepa-filter.
- Replace the compartment lid and push it
into position until it locks into place.
Cleaning and care
●
Before cleaning the appliance, ensure it is
switched off and disconnected from the
power supply.
10