Elbro SMSB-M20T-AB Bedienungsanleitung Seite 29

SMSB-M20T-AB
RING Mode
Functions
Bistable mode
The output status of the device switches (from ON→OFF or else from OFF→ON) upon receiving a voice
call sent by an Enabled User or in local mode.
The function can only be enabled via SMS.
Pulse mode
The device output is activated for a preset time (presettable via SMS, from 1 to 10 sec) upon receiving a
voice call sent by an Enabled User or in local mode.
The function can only be enabled via SMS.
T
FUNCTION
This function allows displaying information regarding ambient temperature in each Status Notification
SMS; it can only be Activated\Disactivated via SMS
Execution of Command Notification
This allows the device to send an SMS to the phone number of an Enabled User after execution of a re-
mote command.
The function can only be activated via SMS during the selection of the type of working mode.
Enabled User
An Enabled User can execute the preset command in remote mode by a simple voice call at no cost (call
towards the phone number of the SIM Card inserted in the device) and, depending on the settings, the
user can choose whether to receive a notification SMS or not.
Once the device recognizes the caller, it refuses the call and performs the programmed command.
The telephone number of an Enabled User is saved in the Phone Book of the SIM card inserted in the
device, and can be added\removed manually (by switching off the device and inserting the SIM Card in a
cell phone) or in remote mode via the A and D commands.
Be careful not to insert manually many times the same number.
Max. number: depends from how many number can be saved on the SIM Card.
The telephone number of an Enabled User must be inserted in international format:
ex. +41335123456789
Default settings
After the first installation, default settings are as follows:
• Password: 0000
• Mode: Bistable
• Notification of Execution of command: OFF
• T : OFF
FUNCTION
• Output: OFF (COM-NC, LED
The default settings can be restored at any moment by proceeding as follows:
• Switch off the device;
• Press and hold down the push button;
• Power up the device (the LED
• When the LED
[ON/OFF]
The settings have been restored.
The above procedure don't remove the enabled users from the SIM Card. To delete them use Command
"C" .
red)
[ON/OFF]
remains unlit for approx. 5 seconds);
[ON/OFF]
lights up, release the push button;
.
E
N
G
L
I
S
H
29