Cleaning Procedure - Gima PINGOO Bedienungsanleitung

READ THE FOLLOWING BEFORE USING
• To avoid electrical shock: Keep unit away from water
• Do not handle the unit or power cord whit wet hands
• Do not immerse the AC adapter or unit in liquid
• Do not use while bathing
• Do not reach for an unit that has fallen into water-
immediatelly unplug the unit.
• Do not use the unit if it has any damaged parts (including
power cord or plug), if it has been submersed in water or
dropped. Promptly send the unit for examination and
repair.
• The unit should not be used where flammable gas, oxigen
or aerosol spray products are being used.
• Keep the air vents open.
• Do not place the unit on a soft surface where the
openings can be blocked.
• If the water tank or medicine cup is empty, do not
attempt to operate the unit.
• If any abnormality occurs, discontinue use until the unit
has been examined and repaired.
• The unit should not be left unattended while plugged in.
• Do not use solution other than water in the tank. It may
damage the transducer.
• Do not tilt or shake the unit when in operation.
• Opening the top cover during operation may cause a
severe injury.
• Disconnect the unit from the electrical outlet before
cleaning, filling and after each use.
• Do not use attachments unless recommended by the
manufacturer.
• The unit should not be used for more than 20 minutes at
a time.
• Wait 30 minutes before reusing the unit.
Operating Caution
• Keep your eyes away from the output of medication mist.
• Charge the water after each use.
• The maximum capacity of the medicine cup is 4.5 ml. and
should not be overfiled.
• Dilute dense medications or medication volume 2 ml. or
less with distilled water or saline solution to obtain a
volume of at least 4 ml.
• Do not use this unit while operating a vehicle.
• If any discomfort or abnormality occurs, stop using the
unity immediately.
Storage Cautions
• Do not store the unit in direct sunlight, hight temperature or
humidity.
• Keep the unit out of reach of small children.
• Always keep the unit unplugged while not in use.
Cleaning Cautions
• Check the medication cup, mouth nozzle and air filter before
each use. Dirty or worn parts should be replaced.
• Do not immerse the unit in water. It may damage the unit.
• Disconnect the unit from the electrical outlet before
clleaning.
• Clean all necessary parts after each use as instructed in this
guidebook.
8

CLEANING PROCEDURE

It is important to clean your PINGOO Nebulizer before
the first time it is used and after each use.
Remember: Disconnect the unit from the electrical outlet and
never immerse the unit in the water.
Cleaning the parts:
The mouth nozzle, nose piece, extension tube, mask, top
cover, medicine, airflow cover, fan and air filter should be
cleaned with a mild detergent or commercially avaible
disinfectant. Thoroughly rinse each part and alow to
competely air dry before using.
Cleaning the main unit:
The main unit should be cleaned with a soft cloth
moistened with a non abrasive cleanser and water.
OPERATING YOUR NEBULIZER
Follow the previous cleaning instruction prior to usig your
PINGOO Ultrasonic Nebulizer for the first time or after it
has been stored for an exstended period.
Remember: Always disconnect the main unit from the electrical
outlet before cleaning and filing and after each use.
To fill the water tank
1. Remove the top cover by pulling
straight up Fig.1. Remove the
medicine cup if applicable.
2. Select either tap or distillated water*
that has a temperature range of 68ºF -
Fig. 1
86ºF (20ºC-30ºC), Fig. 2 *Distilled
water is preferred.
3. Fill the water tank with tap or distilled
water to the indicated level (between
the 2 lines located inside the water
tank). Fig. 3
68°F-86°F
20°C-30°C
Remember: Do not use solution other than
water in the tank. It may damage the
Fig. 2
tranducer - Fill to the correct level.
Note:The use of cool water (below 68ºF or
20ºC) will result in a lower rate of
nebulization.The use of warm water (above
86ºF or 30ºC) will result in a higher rate of
Fig. 3
nebulization.
To fill the medicine cup
1. Place the medicine cup inside the water tank.
2. Pour the medicine directly into the medicine cup.
3. Replace the top cover.
Remember:
• The maximum capacity of the medicine cup is 4.5 ml. and
should not be overfilled.
• Dilute dense medications or medication volumes 2 ml. or less with
distilled water or saline solution to obtain a volume of at least 4 ml.
• Only use medications under the instructions of your physician.
To connect the AC adapter
1. Insert the adapter plug into the unit's
AC port, Fig. 4.
2. Plug the adapter into a standard AC
outlet.
Fig. 4