Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning and maintenance
of
your appliance
Clean
the
blades with
the
brush provided after every
use
(see Fig. 4). Oil the clipper blades at least once a day at the
exact points described in
Fig.5. Just 1drop
per lubricating
point. After lubrication, briefly switch on the appliance
to
spread
the
oil.
A
thorough cleaning
with
the
clipper blades
removed
is
recommended
from time
to
time.
Before detaching
the
clipper blades, the appliance must be switched off and
the
plug disconnected. The screws are loosened with the help of
a cross-tip screwdriver
and
the clipper blades are taken
out
(see Fig. 6). All the hair shavings can then be removed using
the brush. When replacing the clipper
b|ades,
care must
be
taken that the small, black blade with the guiding groove
is
placed on
the
wedge-shaped, plastic auide
of the
machine
and that the drive spigot
fits
into the recess in the clipper
blade (see
Fig.7,
A). Then the large
clipper blade is inserted.
Care must be taken that the screw-holes in the large clipper
blade are placed exactly over the threaded bushin9s of the
appliance (see
Fi9
.7,
B).Once this
step is accomplished, the
two screws can
be
tightened. It is not necessary to align the
two clipper blades especially.
Wipe dirt from casing using
a
soft cloth, Do not use any solvents
or lubricants. Ensure that the electric contacts are always kept
clean, as well.
If the cutting performance deteriorates after a certain
period
of
use despite regular care,
it is
time
to
replace
the
clipper
blades. These are obtainable from your stockist.
Technical data table
Power
10W
Attachment combs
set
of 4
(3.0 ffiffi,
6.0
ffiffi,
10,0 mm, 13.0 mm)
Cable
length
2,B0
m
Weight of appliance
440
g
Werbung
