Panlux PARK S ZOM-S-20/B Gebrauchsanweisung Seite 3

INSTRUCTIONS
MODEL:
ZOM-S-20/B/C
ZOK-S-20/B/C
ZPK-S-20/B/C
ZPP-S-20/B/C
Before using or installing the product, kindly read the instructions and follow safety rules. Installation should
be provided by qualified person or company.
Thank you for choosing the item of company PANLUX s.r.o.
Technical data
Power supply: 230V~50Hz
Power: max. 60W
Supply in standby mode: <0,9W
Additional load: max. 60W (incandescent lamp)
Lampholder: E27
Protection class: II.
IP Protection: IP33
Angle of detection: horizontal – 130°, vertical – 60°
Rotation of sensors head: horizontal - ±45°
Reach: max. 12m (SENS), adjustable
Time setting: 10s (±5s) to 4min (±1min) (TIME),
adjustable
Twilight setting: 10-200lx (LUX), adjustable
Recommended installation height: 2,5m
Terminal block: 3x1,5mm²
Operating temperature: -5°C~50°C
Location: interiors, exteriors
Dimensions: 240x200x280mm
Ball diameter: 200mm
Scroll diameter: 84mm
Weight: 550g
Material: plastic PP/PMMA
Installation
1
2
plastic ball
light source
lampholder
280mm
240mm 200mm
Notice
Before using, check the product and make sure there is no damage,
otherwise do not use it.
Before every manipulation assure that mains electrical supply is
disconnected.
In case of damage do not repair or disassemble the product.
For the best functional results, move toward the sensor (see to pic. 6).
The incorrect function of the product can be caused by interruption
of electromagnetic field, small temperature difference between
moving object and surroundings, reflection (e.g. strong luminous
source).
Before replacing the light source switch off the light and let it cool
down.
Kindly use only recommended light sources (max. 60W).
Do not use small size fluorescent bulbs (diameter smaller than 60mm).
Infringement of any mentioned instruction can cause harm to health
or property.
Accessories:
Reserve globes – milk (ZOM-200), smoked (ZOK-200),
prisma smoked (ZPK-200), prisma transparent (ZPP-200)
terminal block
case
sensor
Principle of PIR sensor
PIR sensor receives infra-red waves emitted by objects in reach radius. With movement in the detection area sensor notices
the change and initiates trigger order „Light on" for adjusted time.
Reach setting (sensitivity) – SENS (max. 10m)
Reach is to be understood as the area traced out by angle of detection and min. to max. available distance from sensor.
Reach can be changed by knob or with rotation of sensors head.
Time setting (switch-off delay) – TIME (10s (±5s) to 4min (±1min))
The countdown of adjusted time begins after last detected movement. We recommend setting the function on minimum
during functional test.
Twilight setting (response threshold) – LUX (10-200lx)
We recommend setting the function on maximum during test.
Stated information may differ according to position and installation height.
Position marked - or  applies to minimum and position marked
If the product is mechanically damaged or connected unprofessionally, guarantee cannot be allowed.
3 4
L
brown
N
blue
blue
L´
black
black
PARK S
Garden lamp with sensor
or applies to maximum.
+
5 6
130°
220˚
60°
max. 10m
2-2,5m
All right reserved. Technical data can be changed without previous notice. UM_PARKS_110826