WTE HPH Montage- Und Betriebsanleitung Seite 60

5.3.1 Normal setting Form AD or JD to DIN ISO 7388
EN
Normal setting of the coolant supply
5.3.2 Change over to Form AF or JF
Change over of the normal setting to coolant supply Form AF.
Risk of burns from hot threaded pin area!
Serious burns and injuries can occur during heating and unscrewing the threaded pins.
 Always wear ISO protective gloves when heating and unscrewing the threaded pins.
 After heating, wait until the heated threaded pin area has cooled down.
60
WARNING
Unless otherwise indicated in the purchase order, the tool hold-
ers are delivered in Form AD.
Montage- und Betriebsanleitung
Installation and Operating Instructions