Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
1.
Plug cord into grounded electrical outlet of the correct voltage. Electrical shock can occur if appliance is
not grounded.
2.
Place food products in a pan, located directly under the bulbs for best results.
3.
Turn unit off when not in use.
4.
To disconnect appliance, turn switch off and remove plug from power source.
CLEANING
NOTE: Proper maintenance plays an important part in the life span and functioning of the warmer.
1.
Unplug the cord and let warmer cool before cleaning or moving.
2.
This unit can be cleaned with a damp sponge and mild soap. Rinse with clean water and wipe dry.
3.
Do not immerse in water or other liquid.
MAINTENANCE
Bulb Replacement
NOTE: Each standard heat lamp is suitable for use with clear or infrared heat lamp bulbs rated at or below 250
watts.
1.
To replace a bulb, place the switch in the OFF position and allow the bulb to cool completely.
2.
Bulbs have a threaded base; unscrew the bulb counterclockwise from the unit and replace with a new
bulb.
FOR SAFE AND PROPER OPERATION, DO NOT INSTALL A BULB BEYOND 250 WATTS INTO THE UNIT.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental safe
recycling.
WARRANTY INFORMATION
The manufacturer provides warranty in accordance with the legislation of the customer's own country of
residence, with a minimum of 1 year, starting from the date on which the appliance is sold to the end user.
The warranty only covers defects in material or workmanship.
The repairs under warranty may only be carried out by an authorized service centre. When making a claim under
the warranty, the original bill of purchase (with purchase date) must be submitted.
The warranty will not apply in cases of:
Normal wear and tear
Incorrect use, e.g. overloading of the appliance, use of non-approved accessories
Use of force, damage caused by external influences
Damage caused by non-observance of the user manual, e.g. connection to an unsuitable mains supply
or non-compliance with the installation instructions
Partially or completely dismantled appliances
www.combisteel.com
4
Werbung
Inhaltsverzeichnis
