Contech ScareCrow Benutzerhandbuch Seite 5

3. Check ScareCrow operation. (Dry test).
First, turn the sensitivity knob to 4 or 5.
3. Check Scarecrow operation. (Dry test)
Next, wave your hand in front of the sensor
First, turn the sensitivity knob to 4 or 5.
lens. You should easily hear the ScareCrow's
Next, wave your hand in front of the sensor
internal water valve click open, then click
lens. You should easily hear the Scarecrow's
closed 3 seconds later. There is an 8 second
internal water valve 'click' open, then 'click'
reset interval after the valve closes when the
closed 3 seconds later. There is an 8-second
sensor does not detect motion.
'reset' interval after the valve closes when
If you hear no clicking, try a new battery and try hooking your ScareCrow
the sensor does not detect motion.
up to water. If the problem persists, call the factory toll-free at 1.800.767.8658
/ 1.250.413.3250 for assistance or email: support@contech-inc.com
If you hear no "clicking", try a new battery. If the problem persists, call the
4. Assemble stake and attach sprinkler head and stake to housing.
factory toll-free at 800-767-8658 for assistance or email support@scatmat.com.
4. Attach sprinkler head and stake to housing.
These fittings should only be hand-tightened.
5. Connect hose and position the ScareCrow.
5. Connect hose and position the Scarecrow(s).
Aim the Scarecrow towards the area you
want to protect. Push the spike into the
Aim the ScareCrow towards the area you
ground by stepping on the footrest.
want to protect. Push the spike into the
Place your hands on the sensor housing ground by stepping on the footrest.
to guide and adjust the Scarecrow's
direction.
Do not push on the sensor housing or
sprinkler head. If the ground is too
hard or otherwise unsuitable for the
plastic stake, try placing the ScareCrow in a flower pot filled with a
weighted material like sand or gravel
Do not push on the sensor housing
or sprinkler head. If the ground is too
Multiple Connections
hard or otherwise unsuitable for the
plastic stake, order the CRO-200 Scarecrow
If you have more than one ScareCrow you can hook them up in series by
removing the flow through cap and connecting them as shown below. Universal Mounting Bracket.
multiple connections
5
 5
These fittings should only be hand tightened.
Sensitivity knob
RESET/OFF
RESET/OFF
Sensitivity Knob
RESET/OFF
CRO-200
CRO-200
CRO-200
5
 5