MAGURA Street-HYMEC Bedienungsanleitung Seite 17

> 1 Guide the slave cylinder through the front fork from the top downwards, routing the hydraulic hose
in the same manner as the OEM clutch cable was routed. Insert the cable end of the slave cylinder into
the primary cover and tighten the threaded end of the slave cylinder. Hold the slave cylinder in the installed
position and rotate the ramp assembly clockwise until any play is eliminated. Now the ball on cable end
of the slave cylinder should be at most +/- 0.1" from the cable coupling. If this is not the case, carefully
readjust the clutch ramp setting.
> Snap the cable ball of the slave cylinder into the cable coupling.
> 2 Unscrew the forward end cap of the slave cylinder and remove the white spacer. Screw the end cap back
on again. Tighten securely.
> Actuate the master cylinder lever twice. The resulting movement of the slave cylinder actuates the ramp
assembly and disconnects the clutch.
> Reinstall the clutch cover and tighten it down, making sure that the sealing o-ring is in position.
> Slide the protective hose over the bush inserted in the hose connector.
> Secure the hydraulic hose to frame with the original clutch cable clamps. Also secure it at other suitable
points with additional cable clamps as necessary to prevent contact with moving or hot components.
> lf possible accommodate excess length of the hose by making a loop in it at a convenient place. This
dispenses with the need to open the system to shorten the hose. Then proceed with the attachment of the
master cylinder to the handlebar. If the hose is not the right length, proceed as follows:
> Loosen the hose connector on the master cylinder with the 8 mm wrench. Remove the master cylinder
from the handlebars and place the opened master cylinder on the workbench so that the opening is facing
upwards and no fluid can leak out.
2
Uk
17