Troubleshooting - Block PS-100+ Bedienungsanleitung

Troubleshooting

Block products are produced under a high quality standard. Only after a strict final inspection, our
devices leave the factory. Any errors that may occur are not automatically material defects or of
technical origin, but can also come from external conditions or other circumstances. The following
list is intended to help you troubleshoot problems:
1. The turntable does not rotate even though the engine is on.
The device is not connected to the power cord.
No power on the socket.
The belt drive is not stretched or has expired.
2. No signal on one or both channels.
Check connection cable and connection to the amplifier. The amplifier is not switched on or is set on
„MUTE". The amplifier is not connected to the speakers.
3. Strong noise on the phono input:
The grounding cable from the turntable to the amplifier is not connected.
4. Distorted or unstable sound from one or both channels.
The input selector switch on the amplifier is not set correctly - MM / MC.
The needle is damaged.
Wrong speed, the belt drive is worn out or dirty. The axle runs without oil or is dirty.
25