Mettler Toledo IND310drive Installationsanleitung Seite 32

IND310drive Installation Manual
Jumpers/LEDs
The Dual analog board has the same jumper connections as a single analog
board. It should always be configured as board 1.
Jumpers/
W1
W5
Jumpers/
W1
2-14
On Off
X X
Table 2-8: POWERCELL Load Cell—Scale 1
On Off
LEDs
IRQ1 X
IRQ2 X
IRQ7 X
W2
W4 X
CS4 X
CS3 X
CS2 X
CS1 X
LED1 X
LED1 X
LED1 X X
Table 2-9: POWERCELL Load Cell—Scale 2
On Off
LEDs
IRQ1 X
IRQ2 X
IRQ7 X
Description
Flashing. Power is on and communication is ok.
W1 is a three-position jumper set. Only one jumper
should be connected.
W2 is a three-pin configuration. If the jumper is in the
12V position, 12 volts is supplied from the IND310drive
terminal. If the jumper is in the 24V position, 24 volts is
supplied from an external power source. The external
power source is connected to J2 on the POWERCELL
load cell board. Pin 1 of J2 is +24V and Pin 2 of J2 is
Ground. The external power source is not supplied with
the IND310drive terminal.
This jumper activates the internal terminating resistor for
RS485.
W5 is a four-position jumper set. Only one jumper
should be connected.
Power on.
Power off. If unit is plugged in, check main power,
power connections, proper seating of the board, and
fuses before contacting service.
Flashing. POWERCELL is connected and communication
is ok.
W1 is a three-position jumper set. Only one jumper
should be connected.
Description
Description