Abus CFA 1000 Bedienungsanleitung Seite 54

Before the adjustments on the door lock actuator are continued, this has to be mounted above
the fastening element on the cylinder lock.
• Insert the key into the cylinder lock, unlock the
lock and put the key into the neutral position
(in which the key could be withdrawn).
• Guide the door lock actuator over the key. Posi-
tion it completely on the fastening element.
• The door lock actuator should be mounted on
the fastening element with the two hexagon
screws extended at first (M3 * 14mm).
Screw in the screws fully with the enclosed
hexagon wrench without applying any force.
Do not tighten screw too strong, otherwise driver could get stuck and possibly
cause malfunctions (e.g. opening door from outside by key could become diffi-
cult).
• Open the door. This is necessary so that the
door lock actuator can detect the end stops
of the lock in the following initialisation drive
without any hindrance.
54