Rainbow audio EL-X6 Einbauanleitung Seite 14

Fit in the loudspeaker and press down slightly until the clamps lock into place. Put in and fix the
loudspeaker grille.
Fig. 1: EL-X69
Installation and Mounting EL-X5, EL-X6
If the placement has been chosen, fix installation template with tape and mark drilling holes. Make the
cut-out for the chassis according to the template (for EL-X you can use the adapter ring as a template).
Drill the holes in indicated size. Remove all metal chips carefully. File edges and use possibly profile
protection or protective lacquer. Fasten the loudspeaker (B) as shown in fig.2 on the installation place.
The loudspeaker connections must always be easily accessible. Use only the provided screws (G) 3.9 x
38 DIN 7981 and the provided sheet metal nuts (I) 3.9 mm.
Do not touch the membrane and don't damage it with the screw driver. Align chassis, make sure
that an even position is guaranteed and tighten finally. Do not over-tighten screws. Insert grille (A) into
the adapter ring (C) and push in firmly. Prepare the cable connections according to instructions and
check the system with low power. After having checked the polarity and mechanical connections you can
operate the system.
Fig. 2: EL-X5, X6
Speaker Cover (A) and installation ring (C) are not included and must be purchased separately.
14