Description Of The Monitor; Operating The System; Troubleshooting - Velleman CAMSETW11N Bedienungsanleitung

3. Description of the Monitor

1. Volume + / -
2. Alarm volume
3. Power
4. +
5. Menu
6. -
POWER – Press to turn the monitor ON or OFF.
ALARM VOLUME – Turn to adjust the alarm volume of the monitor.
VOLUME – Adjust the sound level by pressing + or -.
+ / MENU / – - LED on: adjust brightness + or -; LED flashing: adjust colour + or -; LED off: adjust contrast + or -

4. Operating the System

a. Scan
Press the SCAN button. The monitor places itself in standby mode and scans the active cameras. If a camera
detects motion, the monitor will display the camera picture and the beeper will emit a sound. The monitor will return
to the standby mode and scan the cameras 2 minutes after the last motion detection. Press MANUAL or AUTO to
cancel this mode.
b. Auto
Press this button to enable the monitor to automatically scan the active cameras. When a camera detects motion, the
monitor will display the picture for a few seconds and emit a sound. Only set the DIP switches in the down position
corresponding to the active cameras to avoid selecting an inactive channel. The dwell time is preset to 4 seconds but
can be adjusted between 2 ~ 30 seconds. To do so, hold the AUTO and MANUAL buttons simultaneously pressed.
Each flash of the LED will increase the dwell time by a second.
c. Manual
Select a specific camera by pressing the MANUAL button. Each press will switch to the next camera. When a
camera detects motion, the monitor will display the picture for a few seconds and emit a sound. Only set the DIP
switches in the down position corresponding to the active cameras to avoid selecting an inactive channel.

5. Troubleshooting

Problem
No camera picture
Blank monitor
Interference
Audio problems
CAMSETW11
Solution
1. Check all connectors. Make sure the cameras and monitor are switched on.
2. Make sure the cameras and the monitor are set to the correct channel.
3. Make sure not to exceed the transmitting range.
4. Make sure the rechargeable battery pack is fully charged.
1. Make sure the monitor is switched on.
2. Plug the AC adapter correctly into the mains or power input jack.
3. Make sure the rechargeable battery pack is fully charged.
1. Make sure not to exceed the transmitting range and to remove all obstructing objects.
2. Try repositioning the camera and/or monitor to improve the reception quality.
3. Remove all other devices using the 2.4GHz transmission frequency.
4. Make sure the rechargeable battery pack is fully charged.
1. Turn up the volume.
2. Make sure the sound is produced within the microphone's range.
3. Try moving the monitor away from the camera in case of feedback.
4 VELLEMAN