Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Orchestra Stand
For your own safety, please read this leaflet
carefully before you initially start-up. You can find
the latest update online.
Safety Instructions
1 Unpack the stand. Before you initially start-up,
please make sure that there is no damage
caused by transportation. Should there be any,
consult your dealer and do not use the device.
2 This device has left our premises in absolutely
perfect condition. In order to maintain this
condition and to ensure a safe operation, it is
absolutely necessary for the user to follow the
safety instructions and warning notes written in
this user manual. Damages caused by the
disregard of this user manual are not subject to
warranty. The dealer will not accept liability for
any resulting defects or problems.
3 If the product will be operated in any way
different to the one described in this manual, it
may suffer damages and the guarantee
becomes void. Please consider that
unauthorized modifications on the adapter are
forbidden due to safety reasons.
4 Stands may cause severe injuries when
crashing! Only install on a plane area with a
maximum inclination angle of 5°.
5 When using stands under the influence of
horizontal forces, e.g. through wind, the
standing safety can be impaired. This is why
additional safety measures like attaching
ballast weights have to be taken. If inclined
tension cables or prolonged outriggers are
used, the area of danger has to be marked or
even be blocked.
6 Before lifting or lowering the telescopic tubes,
you must always block a safety area around the
stand. This safety area must have a diameter of
1.5 times the maximum height.
7 Before taking into operation, every stand has to
be checked upon possible damages. If one part
of a stand is defective, the stand must not be
taken into operation.
Installation
(1) Telescopic tube
(2) Fixation screws
(3) Stand tube
(4) Legs
1 Loosen the fixation screw of the legs. Pull the
legs out until they stand at a 45° angle to the
tube stand. Tighten the fixation screw of the
legs.
2 Loosen the fixation screw of the telescopic
tube. Carefully pull out the telescopic tube to
the desired height.
Do not exceed the carrying capacity of the stand.
Do not exceed the maximum extension height.
Technical Specifications
Maximum load
Minimum height
Maximum height
Support
Every information is subject to change without prior
notice. 27.01.2014 ©
00081461.DOCX, Version 1.1
Item 60006520
3 kg
900 mm
1400 mm
470 x 325 mm
Werbung
