Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The installation of the
SMXX_GLAS has to be in a
distance between 20mm and
50mm from the window
frame on the clean inside
glass. Glue the sensor on
the cleaned glass surface
with a two-component glue.
Mind the instructions of
handling included to your
two-component glue.
Please make sure, that it is
recognizable visually when
the sensor is removed from
the window. Make the cable
laying always bottom-up or
horizontal.
Mind during the installation of the sensor on windows (or doors), that the cable is layed in
direction of the center of rotation. Please mind also, that the cable will not be
mechanically stressed or squeezed.
Connection to the SITEMANAGER, SITEMONITOR, SENSORMANAGER
The connection of the SMII_GLAS and SM64_Glas to the SITEMANAGER resp.
SITEMONITOR is to be done by the open sockets at the digital inputs.
The connection of the SM_GLAS to the SENSORMANAGER is to be done by the RJ12-
connector.
For informations about the configuration and control of the events in case of an glas
breakage alarm, please follow the manuals included to your facility management device.
Technische Daten
Power supply
Current consumption
Temperature range
Max. switching voltage / current 28VDC / 100mA
Alarm relay
Measurements
Weight
Connection calbe
Fig. 3:
Installation of the SMXX_Glas
10-15VDC
5mA (normal) / 17mA (alarm)
-40°C bis + 70°C
NC
18x18x9mm
80g
4 meter
Werbung
