Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S3264
AIR SOURCE
Clean air of correct air pressure is recommended for the power supply for this tool. A
maximum of 90 PSI at the tool is recommended for most air tools of this class. Check
specifications section for recommended pressure. (Depending on length of air hose and
other circumstances, air pressure at compressor may need to be increased to 100 PSI
to ensure 90 PSI at the tool.) Water in the air hose and compressor tank contributes to
reduced performance and damage of the air tool. Drain the air tank and filters before
each use and when necessary to keep the air supply dry. Hose length over 25 feet
causes loss in line pressure. Increase hose ID or increase compressor pressure to
compensate for the pressure loss. Use an in-line pressure regulator with gauge if air
inlet pressure is critical.
No. Description
1
Tool
2
Quick Coupler
3
Air Hose
4
Quick Coupler
5
Air Valve
LUBRICATION & MAINTENANCE
Warning!
Oil tool before each use. 4 to 5 drops air tool oil placed in the air
inlet is sufficient.
Use proper air pressure and CFM rating listed for this tool.
Drain water from hoses and compressor tank.
Water in the air supply line damages the tool and causes a loss of power.
Clean or replace air filters at prescribed intervals.
DISPOSAL
If the tool is too seriously damaged to be used anymore,
drop it in a resource recycling can.
Never drop it into fire.
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Strasse 65
D-42897 Remscheid
No. Description
6
Oiler
7
Regulator
8
Water Separator
9
Compressor
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
Werbung
Inhaltsverzeichnis
