Werbung
Connecting the Adapter to
the Tap:
1. Remove the tap nozzle.
2. Screw on the adapter using
the supplied rings and seals.
NOTE! If the adapter does not
fit, remove the large washer.
Connecting the Drain Clean-
ing Hose
1. Make sure the tap is closed.
2. Screw the drain cleaning
hose onto the tab adapter.
The cut-off valve on the
adapter must be closed.
Flushing the Drain
1. Insert the nozzle into the
clogged drain.
2. Hold the hose firmly in the
drain and turn on the water.
The water must be luke-
warm, not hot. Open the cut
off valve on the adapter.
3. Move the hose up and down
in the drain until the block-
ade is cleared.
If the device is connected to a garden hose use the included garden
hose adapter.
Hose Length 2.5 m, Hose Diameter 3/8" (~10 mm)
Diameter Adapter Threads: ¾", ½" interior, W 24 x
Operation
5
1
/
"
10
Werbung
