Waeco TropiCool TCX14 Bedienungsanleitung Seite 23

TCX14, TCX21, TCX35
6.4 Switch over between cooling and heating
➤ If you want to switch over between cooling and heating, press the
button "HOT/COLD".
I
NOTE
The control unit of the cooling device has a memory function.
It memorises the selected temperature range for each mode
(cooling and heating). Thus the temperature range which is
previously selected in the mode is set again with each switching
on or switching over.
✓ The red or blue operating display lights up and the device starts to cool/
heat.
➤ When you want to finish the cooling or heating process, press the
button "P".
➤ When you stop using the cooling device, disconnect it from the mains.
6.5 Select temperature
The status display of the temperature (fig. 3 5, page 3) indicates the
selected temperature range. With an increasing number of illuminating LEDs,
the intensity of the temperature range also increases.
I
NOTE
The following temperature indications are subject to tolerances
and are dependent on the measuring position.
Interior space temperature at approx. 25 °C ambient temperature:
Status display
seven illuminating LEDs
Cooling
an illuminating LED
seven illuminating LEDs
Heating
an illuminating LED
➤ If you want to select the temperature to cool/heat, press the button " ",
until the requested temperature range is reached.
EN
Temperature range
approx 0 °C in the interior space
approx 16 °C in the interior space
(ECO mode)
approx 65 °C in the interior space
approx 48 °C in the interior space
Operation
23