Grease Filter; Carbon Filter - Amica OSC 5562 W Gebrauchsanweisung

VI OPERATION AND MAINTENANCE
3. Maintenance.
Regular maintenance and cleaning of the device will guarantee its good and fault-less operation, and
extend its life. Attention should be paid to replacing grease and carbon filters according to instructions.

3.1 Grease filter

a) Cleaning
The grease filter should be cleaned at least every two months during normal operation of the hood. The filter can
be dismantled by releasing its securing studs (Fig. 5), keeping in mind that the filter has to be protected with your
hand during releasing the studs, removing catches D which secure the filters (Fig. 6), then you can clean the filter
and reinstall the catches and the mesh.

3.2. Carbon filter

a) operation
Carbon filters (C Fig. 6) can absorb odours until they are saturated. They cannot be washed or rege­
nerated and should be replaced at least every 2 months or more frequently in case of very intensive
use.
b) replacement
- remove masking cover A (Fig. 6) together with grease filter B,
- replace carbon filter C situated on the textile filter B,
- install the grease filter with the carbon filter in the hood.
3.3. Lighting
The lighting system consists of 28W Halogen light.
To replace a light bulb proceed as follows:
a) remove the masking cover A from the hood body (see section 3.1 a)
b) replace the bulb using a piece of cloth or paper for that purpose,
c) install the masking cover A.
3.4. Cleaning
The following shall be avoided during normal cleaning of the hood:
• wet cloth or sponge and water jet,
• solvents or alcohols which might dull lacquered surfaces,
• caustic agents, particularly in regard to cleaning stainless steel elements,
• hard, rough cloth
It is recommended to us moist cloth and neutral cleaning agents.
Aluminum filters may be washed in the dishwasher. Color of aluminum filters may change after
several washings. This is normal and it is not necessary to change the filters.
58
EN