Initial Start-Up; Tips And Suggestions - h.koenig AGR60 Bedienungsanleitung

Note
The large cone can only be used when it is assembled on the small cone.
Spout of the juice container
The juice container(5)has a spout (5A)that can be raised (fig. C) or lowered(fig. D)
During use, If the spout of the appliance is in a raised position. Then the juice remains
inside the container. On the other hand., if the spout is in the lowered position, then the
juice falls directly inside a glass or container placed under the spout.
To change the position of the spout, move the spout upwards or downwards with a light
pressure.
Note
After use, the spout must always be in the raised position(fig. C)

INITIAL START-UP

 Rest the appliance on a horizontal and stable surface away from heat sources.
 Assemble the appliance by following the procedure indicated in flg.1.
 Select the type of cone in relation to the size of the citrus fruit and move the spout of
the container to the desired position: raised or lowered (refer to the section on
"Accessories and Container Spout")
 Completely unwind the power cord and connect the plug to power outlet.
 Cut the citrus fruit in two sections and press each half lightly on the juicing cone. The
juicer starts to turn. Simply remove the pressure from the cone to stop the juicer.

Tips and suggestions

To get as much juice as possible from the fruit, press the citrus fruit onto the cone several
times instead of keeping it continually pressed.
Attention!
 Too much pressure on the cone may cause the motor to block.
 Do not let the juicer operate for more than two minutes consecutively.
 Wait five minutes between each use to allow the motor to cool.
 Do not let the power cord hang from the bench top.
 Do not insert sharp cutlery or objects while the cone is moving.
 After use, disconnect the plug from the power outlet and place the spout in a raised
position(fig. C).
.