Blaupunkt LPSA 754303 Bedienungsanleitung Seite 15

OPERATING INSTRUCTIONS
Installing the Battery Pack
• Slide the battery pack into the tool base, Fig.3. (Note the battery has raised grooves which allows it to fit into the inflator only
one way).
• Make sure the battery pack snaps into place and that battery pack is secured in the tool before beginning operation. Improper
installation of the battery pack can cause damage to internal components.
Removing the Battery Pack
• Locate the battery release catch on the top of the battery and press downwards, Fig.4.
• Whilst holding down the battery release catch slide the battery pack away from the tool.
Using the Air Pump
• To secure the air hose to the air pump loosen the adaptor locking collar by turning it counter-clockwise, Fig.5.
• Insert the air hose into the adaptor locking collar, Fig.6 and tighten clockwise.
• Attach the chosen adapter to the air hose and screw clockwise until it is securely in place, Fig.7.
• Warning! Improperly attached hoses or accessories can become detached under pressure and cause serious injury. Possible
air leaks can cause faulty pressure readings. Make sure all connections are tightly secured.
Turning the Air Pump On & Off
• Squeeze the trigger to start the air pump, Fig.8.
• During use check the pressure gauge, Fig.9 for the desired pressure. When desired pressure is achieved release the trigger to
stop the air pump. NEVER over inflate as damage or injury may occur.
Accessories
The supplied accessories perform a variety of functions. The tapered adaptor can be used on smaller pinch valves to inflate small
items like floats and children's toys, which usually require the user to inflate them by blowing air into them. The sports ball needle
can be used to inflate any type of sports ball or any other item that requires an inflation sport ball needle.
NOTE: When inflating items of 10 PSI or less, inflate in short bursts and check after each burst by feel or with a calibrated measuring
device to determine accurate pressure.
Sport Ball Needle
• The sports ball needle can be used to inflate any type of sports ball or any other item that requires an inflation sport ball
needle.
• Insert the sports ball needle into the sports ball valve and inflate. Remove the sports ball needle after inflation.
NOTE: Pressure required for most sports balls is too low for accurate reading on tool pressure gauge.
Tyre Adaptor
• Screw the threaded connector onto tire's valve stem quickly.
• When connected, the gauge will show current tyre pressure.
Product Specifications
Voltage
Hose Length
Maximum pressure
Air Flow Rate
Duty cycle
Sound Pressure Level
Sound Power Level
Vibration Level
18V DC
550mm
8 bar/150 PSI
12 l/min
5 mins On, 5 mins Off
LpA 69 dB(A) K=3dB(A)
LWA 80 dB(A) K=3dB(A)
2.342 m/s2, K=1.5m/s2