Settings In Watt Mode (Power) - uwell Ironfist Bedienungsanleitung

51
UWELL Ironfist – Using the device
Selecting the Operation Modes
Push the fire button three times quickly in succession in order to open mode selection.
The mode display blinks and you can now switch between watt mode (POW), temperature
mode (NI, TI, SS), and bypass (MECH) by pressing the single buttons and then confirm
your selection with the fire button.

Settings in Watt Mode (Power)

Press the Up or Down button in watt mode to set the watt number. Hold down the corresponding
button to select the number more quickly. The watt settings can be configured from 5 to 200
watts. If you drop below 5 watts or exceed 200 watts, you will automatically switch to the highest
or lowest watt value.
Note: If the vaping voltage is too low, the output power will not be capable of reaching the
desired pre-settings, since the output power automatically adapts.