Setting The Preheat Function In Temperature Mode (Power) - SC Tessera Set Bedienungsanleitung

SC TESSERA – COMMISSIONING OF THE DEVICE
Note:
Please use this lock function only at room temperature so that the correct base resistance can be displayed in
lock mode� If this is not the case, faulty measuring results can occur which can also adversely affect the protective
functions�
Setting the Charging Protection (ENU)
Under the SET menu item, you can select the ENU submenu and turn it to ON or OFF� When it is set to ON, the de-
vice is plugged in for charging, and the temperature of the device is lower than -5°C or higher than 45°C, the screen
will display ‚BATTERY TOO COLD' or ‚BATTERY TOO HOT' � In both cases, the device will not charge� If the temperature
during charging is even higher than 50°C, the device will not charge until the temperature drops below 45°C again�

Setting the Preheat Function in Temperature Mode (POWER)

The POWER option under the SET menu item enables the device to heat the coil with an individually configurable
amount of power in temperature mode�
Sub-Parameter (SUBPARA)
The sub-parameters in the SET menu item include the total number of vapes (PUFF), the total vape time (TIME) and
AMP (current ampere)� You can select which of these should be displayed on the main interface�
65