Operation; Technical Data - Renkforce 1522167 Bedienungsanleitung

Operation

• Attach the spray head (2) to one of the two mountings (7) until it clicks into place.
• Attach the hose connector (9) to the other mounting until it clicks into place.
Both mountings are of same size. For that reason it does not matter to
which mounting you attach the spray head or hose connector.
• If necessary, screw the thread adapter (8) into the hose connector.
• Connect the hose connector to a suitable water tap.
• Open the water tap.
• Press the trigger (5) towards the handle (3) in order to let water emit from the
spray head.
• Turn the adjusting ring (1) in order to switch between the 7 functions of the spray
head.
- FOG
- JET
- SHOWER
- FLAT
- CENTER
- CONE
- FULL
• Control the force of the water jet by turning the adjusting screw (10).
• If necessary, lock the trigger using the locking lever (11) for continuous watering
(see illustration below).
• Close the water tap after use.
• Pull down the ring from the mounting in order to disconnect the spray head or hose
connector from the hose.
Cleaning and care
• Besides occasional cleaning, the product is maintenance-free.
• Use a damp cloth for cleaning. Use a mild cleaning agent to clean off tougher dirt.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical
solutions.
• Store the product at a dry, clean location shielded from direct sunlight and out of
the reach of children.
Disposal
At the end of its service life, dispose of the product in accordance with applicable
regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the
environment.

Technical data

a) Item no. 1522162
Material ................................... Latex (hose)
Polyester (coating)
ABS (plastic components)
Operating pressure ................. approx. 3.5 bar
Burst pressure ........................ approx. 14 bar
Hose Ø ................................... 6 mm (internal)
9.5 mm (external)
Water inlet Ø ........................... 15 mm
Wall thickness ......................... 1.75 mm
Operating conditions ............... -10 to +50 °C, 0 – 100 % RH
Storage conditions .................. -10 to +50 °C, 0 – 100 % RH
Length..................................... 5 – 15 m
Weight .................................... 700 g (hose)
90 g (spray head)
40 g (connector)
b) Item no. 1522167
Material ................................... Latex (hose)
Polyester (coating)
ABS (plastic components)
Operating pressure ................. approx. 3.5 bar
Burst pressure ........................ approx. 14 bar
Hose Ø ................................... 6 mm (internal)
9.5 mm (external)
Water inlet Ø ........................... 15 mm
Wall thickness ......................... 1.75 mm
Operating conditions ............... -10 to +50 °C, 0 – 100 % RH
Storage conditions .................. -10 to +50 °C, 0 – 100 % RH
Length..................................... 10 – 30 m
Weight .................................... 1380 g (hose)
90 g (spray head)
40 g (connector)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE. *1522162_7_V1_0117_02_IPL_m_en